![mt10 ecu flash mt10 ecu flash](https://i.ytimg.com/vi/WgZqnOGjVzc/maxresdefault.jpg)
You can weld this bung into exhaust systems that do not have a Wideband O2 bung. High Quality 18mm Stainless Steel Wideband O2 Bung.
![mt10 ecu flash mt10 ecu flash](https://stoltecmoto.com/wp-content/uploads/2017/11/Active-Tune-Kit-Web.png)
Zeitronix ZT-3 Wideband O2 Installation Guide Additional Bin File Definition Keys are required for each additional ECU's and can be purchased from within the WRT software. This product comes with 1 Bin File Definition Key allowing you to tune 1 ECU's as many times as you like.
![mt10 ecu flash mt10 ecu flash](https://876881.smushcdn.com/2204290/wp-content/uploads/2016/04/FTE_AB_image-LARGE-scaled.jpg)
Pit Lane Limiter - (Requires Race Tools).
#Mt10 ecu flash software#
Purchase this item to gain access in the Woolich Racing Tuned software to the stock bin files for the 2016-2021 Yamaha MT-10įeatures available for Yamaha FZ-10 / MT-10 2016-2021
#Mt10 ecu flash install#
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).Ģ016-2021 Yamaha FZ-10 / MT-10 Launch Control Keyīin File Definitions - for use in Woolich Racing Tuned softwareĢ016-2021 Yamaha MT-10 Stock Bin File Definitions You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. *** The Pit Speed Limiter / Engine Warm Up requires the purchase of an additional Pit Speed Limiter harness ** This harness uses the O2 Sensor plug on the bike's harness, the stock O2 sensors should be removed from the bike and disabled in the WRT software * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Pit Speed Limiter RPM can be configured.***Įngine Warm Up parameters are configurable.*** Launch Control allows you to configure Delay, Launch RPM and Hold Speed.
#Mt10 ecu flash full#
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.Īutoblipper Opening and Duration maps are fully configurable per gear. Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.Yamaha Race Tools Type 2 which allows the quickshifter to be plugged into the bikes wiring harness**.Shift rod for standard shift configuration*.High quality dual direction strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.The Race Tools package allows you to add Autoblipper, Quickshifter, Engine Warm Up, Pit Speed Limiter and Launch Control to the Stock Yamaha MT-10 ECU. Race Tools: Quickshifter, Launch Control, Pit Speed Limiter